[ddots-l] Re: recording drums delta 44
- From: "Phil Muir" <philmuir1@xxxxxxxxxxx>
- To: <ddots-l@xxxxxxxxxxxxx>
- Date: Tue, 13 Jun 2006 17:37:58 +0100
Well, you want to bring in as many individual inputs as possible. How many
does your Delta 44 have?
Regards, Phil Muir
P J Muir Productions
Music and audio production
URL: www.philmuir.com/
----- Original Message -----
From: Rod
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, June 13, 2006 5:06 PM
Subject: [ddots-l] Re: recording drums delta 44
Thanks for the suggestions so far, but I am more looking on suggestions on
how I can go about making sure that everything is miced the right way. Since I
only have the ability to record out of one AUX send on the yamaha at a time,
and only one preamp channel, how would you envision setting this up. It seems
that I will only be able to capture only two mics at a time. The one out of the
yamaha, and the 1 channel preamp. If I capture 4 mics, as Phill suggested, they
will all mix together, because they will be coming out of that one Aux send on
the mixer. is that the way it should be? Sorry for the elementary questions,
this is my first time recording live drums.
Thanks
Rod
----- Original Message -----
From: kurt Streuber
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, June 13, 2006 10:16 AM
Subject: [ddots-l] Re: recording drums delta 44
Well, I'd say try micing the kick, and maybe run the snare through your
preamp, since that's what stands out the most in a kit, at least usually. I'd
try the Ortf overhead pair on the kit, I use it a lot, and it produces really
good results. Basically you set up a stand, and center it so your high tom is
a bit left, mid is almost dead center, and low is right. Then find a T bar at
your music store, this allows uyou to use two mics on one stand. You have the
center section of the T bar parallel to the floor, or flat across, and the two
sides dangling down and away from the center so you get a shape that's like a U
with the side pieces pulled apart slightly at the top, or an open trapezoid.
You put two mics on the bar, and have them crossing over each other, so both
capsules point down and away from the stand, one pointing towards left and one
right. It's hard to explain, but you want the mics to be laying on top of each
other, in sort of a squished X shape, so the capsules are about 6 inches apart,
and at a 110 degree angle. I've probably confused you, but if you cross your
arms, and your hands are the ends of the mic, you want your hands 6 inches
apart, and at that angle. What you get is a mic for each side of the kit, and
it produces a very wide stereo image and a good balance. The best way to do it
is with a boom stand, set in front of the kick and up pretty high, about 5 or 6
feet. The boom comes out over the drums and the mics point down. Sorry for
not being able to depict this very well.
Kurt
----- Original Message -----
From: Rod
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, June 13, 2006 6:51 AM
Subject: [ddots-l] recording drums delta 44
Hi, guys:
I have a delta 44 card, and I need to record a live drummer, any tips on
how I can go about doing this?
I have a Yamaha mg 12 channels mixer, and a one channel presonus
eureka preamp. I would appreciate any response please.
Rod
Other related posts:
