MessageThe blank page problem is probably caused by too many hard page breaks. ----- Original Message ----- From: Denise and Jim To: duxuser@xxxxxxxxxxxxx Sent: Tuesday, February 14, 2006 4:41 PM Subject: [duxuser] Re: Line spacing problem Hi George, What would be an alternative to hard carriage returns if you want to do many spaces inbetween lines? I make mini books for my young kids and need to make multilines to space to cut and put together in a small book. I am currently having problems with the document. It looks correct on the computer screen in duxbury but when I emboss it the lines just keep rolling off the page into the right margin and off the paper. I have done embosser global and document adjustments but still does this. It also leaves a blank page in between each print page. Someone in the office suggested today that maybe it was the hard carriage returns. What say you? Denise ----- Original Message ----- From: George Bell To: duxuser@xxxxxxxxxxxxx Sent: Tuesday, February 14, 2006 12:39 PM Subject: [duxuser] Re: Line spacing problem Hi Don, It rather sounds like the Word document might actually have had hard carriage returns at the end of each line, as opposed to being properly double spaced. If you don't have anyone or any way to check, e-mail the Word Document to me at george@xxxxxxxxxxxxxxxxxxx and I'll check it. George. ---------------------------------------------------------------------------- From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of dhansen@xxxxxxx Sent: 14 February 2006 15:28 To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] Line spacing problem Hello: I recently imported a Word document into DBT that was single spaced in Word, but came out double spaced in DBt. The shift F 1 command did not work. I ended up deleting the extra lines individually. Fortunately, it was a short document. Can anyone tell me what the problem is? I'm using DBT 10.5 and Word 2003 Don Hansen