[duxuser] Re: Question about dbt 10.5 and global embosser set-up
- From: "George Bell" <george@xxxxxxxxxxxxxxxxxxx>
- To: <duxuser@xxxxxxxxxxxxx>
- Date: Fri, 5 May 2006 14:40:50 +0100
Hi Ann,
In Global: Embosser Setup, click on the Edit button. On the
General Tab, go down to the "Default Form" listbox, and
select you default size there first, then click on O.K. Now
make sure that the Form size in that dialog is correct and
click O.K. All being well, it should stick.
George.
-----Original Message-----
From: duxuser-bounce@xxxxxxxxxxxxx
[mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Foxworth,
Ann
Sent: 04 May 2006 22:46
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] Question about dbt 10.5 and global
embosser set-up
Whi is it that when I set global embosser set-up to narrow
paper, it always goes back to wide paper? And why is it
that when I have set global to narrow paper in an open
document and go to emboss, wide paper is selected? Is there
a way to set a default?
Ann Foxworth, Braille Consultant
Criss Cole Rehabilitation Center
4800 N Lamar Blvd.
Austin, TX 78756
PH: (512) 377-0471
* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may
also
* subscribe, unsubscribe, and set vacation mode and other
subscription
* options by visiting //www.freelists.org. The list
archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *
* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting //www.freelists.org. The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *
Other related posts:
