Yep, we're having the same problem here with all our networked embossers. It is not a Duxbury thing, I don't think so anyway. It seems to be something about the drivers, someone even mentioned that the generic printer choice was the culprit. I hope someone finds out what this and so we can fix it. Ann Foxworth, Braille Consultant Div. for Blind Services 4800 N. Lamar BLVD Austin, TX 78756 PH: 512-377-0471, E-mail: ann.foxworth@xxxxxxxxxxxxxxxx -----Original Message----- From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Janet Reynolds Sent: Thursday, August 18, 2005 11:10 PM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] extra form feeds Has anyone come across this one before? We have just upgraded the PC that is used as a printserver in our embosser room. Now, when a Duxbury job is sent from any PC on the network to any of the embossers, we get two and a half form feeds at the end of the job. The printserver PC is XP and the driver is set up as Generic/Text only as before. It's interesting that if you send the job from DBT on the printserver PC itself, you don't get the extra form feeds if you point Duxbury at LPT1, but you do if you point it at the network address of the embosser. The network uses the standard TCPIP protocol and our network support folk can't think of anything in there to cause this effect. We could live with one or two form feeds but it's the half that is the killer! Janet * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *