Hi Arjen, For relatively safe welding at home/outdoor, I suggest an inexpensive 110v flux-core welder (no gas needed). Buy high quality wire to minimize splatter, and go easy on the trigger at lowest setting for tubings. Do spot welding if needed to control the heat on very thin tube. If you have access to a shop with other methods, try them all which should be strong enough for tubings, but differ in control, heat, beads, and safety hazards. Here are some claims by Greenspeed: The frame tubes are MIG welded. MIG beads are not as fine as TIG, though the craftsmanship of the Greenspeed is exceptional. We don't see many MIG welded recumbents, so we asked Ian about it, "We find that MIG welding puts less heat into the tubing than TIG, and a lot less than brazing, leading to less of the metal around the joint losing its strength. We have also had superior performance from the MIG joints over brazed joints. In addition, we find that the MIG is quicker than TIG, and much faster than brazing, thus is is much better suited for production work". http://www.greenspeed.com.au/rdtest1.html Enjoy, Vi >________________________________ >From: nerdie <nerdie.spam@xxxxxxxxx> >To: python@xxxxxxxxxxxxx >Sent: Tuesday, May 31, 2011 1:51 PM >Subject: [python] Welding or brazing? > > >Hy Pythonauts, > >I looked in the mailinglist, but i cant seem to find a satisfying answer to >this question: Welding or brazing when building a bike? > >What are the pro' s and con's? (strength, easyness, costs) > >Kind regards, > >Arjen > > > > > >