Hello Pranav
Thanks a lot. Although I admit that you have much more knowledge about the
PI and setup etc. I just want to point out that I used RawWrite on a
windows10 pc to create images for the PI and I did not have any problems, so
I do not know if you tried it?
Regards
Fanus
-----Original Message-----
From: raspberry-vi-bounce@xxxxxxxxxxxxx
[mailto:raspberry-vi-bounce@xxxxxxxxxxxxx] On Behalf Of Pranav Lal
Sent: Wednesday, January 27, 2021 12:27 PM
To: raspberry-vi@xxxxxxxxxxxxx
Subject: [raspberry-vi] Re: Install Speakup and Orca on Raspberry OS
Hi Fanus,
Yes but the problem at least with my installation of windows 10 and the
etchar program which is what I am using is that the card is not being burnt
correctly.
Try etchar and the raspberry imager and see if you can burn the image to the
card.
Pranav
===========================================================
The raspberry-vi mailing list
Archives: //www.freelists.org/archives/raspberry-vi
Administrative contact: <mike.ray@xxxxxxxxxxxxxx>
-----------------------------------------------------------
Raspberry Pi and the Raspberry Pi logo are trademarks of the Raspberry Pi
Foundation.
This list is not affiliated to the Raspberry Pi Foundation and the views and
attitudes expressed by the subscribers to this list do not reflect those of
the Foundation.
Mike Ray, list creator, January 2013
===========================================================
The raspberry-vi mailing list
Archives: //www.freelists.org/archives/raspberry-vi
Administrative contact: <mike.ray@xxxxxxxxxxxxxx>
-----------------------------------------------------------
Raspberry Pi and the Raspberry Pi logo are trademarks of the Raspberry Pi
Foundation.
This list is not affiliated to the Raspberry Pi Foundation and the views and
attitudes expressed by the subscribers to this list do not reflect those of the
Foundation.
Mike Ray, list creator, January 2013
