[ddots-l] Re: Reading Bus Input Meter?
- From: "Chi Kim" <ms22282@xxxxxxxxxxx>
- To: <ddots-l@xxxxxxxxxxxxx>
- Date: Tue, 19 May 2009 15:36:07 -0400
It's not going to work when there's a limiter on the bus which makes the output
level below 0 always.
----- Original Message -----
From: luis elorza
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, May 19, 2009 3:10 PM
Subject: [ddots-l] Re: Reading Bus Input Meter?
just an idea, set the bus output to 0 and read the output meter, that should
be the same as the input as long as you didn't make any change to the signal.
i believe sonar does not show metering for the bus input though i may be
wrong.
----- Original Message -----
From: Chi Kim
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, May 19, 2009 8:17 AM
Subject: [ddots-l] Re: Reading Bus Input Meter?
Thanks Phil,
That'd be quite a work switching back and forth and turning on and off the
limiter.
Can you ask david to implement ways to read both peak and RMS meters for
input and output? Those are essential in audio production! I'd really
appreciate it.
Also, we should have a way to read output meter even if the track is armed.
Chi
----- Original Message -----
From: Phil Muir
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, May 19, 2009 9:58 AM
Subject: [ddots-l] Re: Reading Bus Input Meter?
In which case, turn the limiter off. That will give you a clearer idea
of how hard your driving the metres on a bus. Alternatively, look at
alternative scripts which give you access to Sonar's VU metres. That way you
may get an idea of how hard your driving the metres E.G, the RMS level that
your hitting the bus at. Finally, if the compressor that your using has
metering fully implemented, read off the various metres such as the gain
reduction metre in the compressor. The Sonitus compressor has full metering
implemented.
Regards, Phil Muir
P J Muir Productions,
Music And Audio Production
Telephone: US (615) 713-2021
UK+44-1747-821-794
Mobile: UK +44-7968-136-246
E-mail:
info@xxxxxxxxxxxx
URL:
www.philmuir.com/
----- Original Message -----
From: Chi Kim
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, May 19, 2009 2:19 PM
Subject: [ddots-l] Reading Bus Input Meter?
CT reports bus output meter, but is there way to read bus input meter
to see how hard I'm driving the bus? If there's a limiter on a bus, I won't
know if I'm clipping the bus or not since the output meter will be always below
0.
Thanks,
Chi
__________ Information from ESET NOD32 Antivirus, version of virus
signature database 4085 (20090519) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
Other related posts:
