[ddots-l] Re: Reading Bus Input Meter?
- From: "Bobby Lusk" <blusk@xxxxxxxxxxx>
- To: <ddots-l@xxxxxxxxxxxxx>
- Date: Tue, 19 May 2009 11:03:14 -0500
Wow! That's why before I go out of town later this week I'm going to
temporarily unsubscribe to the free-list so I don't have that many e-mails to
go through when I get back.
God bless you.
Bobby Lusk.
----- Original Message -----
From: Chi Kim
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, May 19, 2009 10:30 AM
Subject: [ddots-l] Re: Reading Bus Input Meter?
Thanks Jean. I'll try that for now.
Yes, 4500 emails from dancing dot, midimag, and jSonar.
Chi
----- Original Message -----
From: Studio Montebello
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, May 19, 2009 11:15 AM
Subject: [ddots-l] Re: Reading Bus Input Meter?
Wow!!!, 4500 messages to read?
You probably burned your "delete" key!!!
Yes, you have to read the input meters from within the compressor window.
Jean
Visitez mon site / Visit my site at http://www.studiomontebello.com
----- Original Message -----
From: Chi Kim
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, May 19, 2009 11:11 AM
Subject: [ddots-l] Re: Reading Bus Input Meter?
Hi Jean,
Yes, I was so busy finishing graduat school. I checked my email for the
list, and there were 4500 emails for me to read...
Anyways, I have to insert the Sonytus compressor and press f2 inside the
compressor window, not from the bus strip, right?
It'd be so much better if CT can read both input and output meter of bus.
Chi
----- Original Message -----
From: Studio Montebello
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, May 19, 2009 10:59 AM
Subject: [ddots-l] Re: Reading Bus Input Meter?
Hi Chee!
Nice to hear from you, it's been a while.
Although I've never tried this, insert a Sonytus compressor on your bus
, then you can read the input levels with the F2 key.
HTH, Jean
Visitez mon site / Visit my site at http://www.studiomontebello.com
----- Original Message -----
From: Chi Kim
To: ddots-l@xxxxxxxxxxxxx
Sent: Tuesday, May 19, 2009 9:19 AM
Subject: [ddots-l] Reading Bus Input Meter?
CT reports bus output meter, but is there way to read bus input meter
to see how hard I'm driving the bus? If there's a limiter on a bus, I won't
know if I'm clipping the bus or not since the output meter will be always below
0.
Thanks,
Chi
Other related posts:
