Hi Jean, Yes, I was so busy finishing graduat school. I checked my email for the list, and there were 4500 emails for me to read... Anyways, I have to insert the Sonytus compressor and press f2 inside the compressor window, not from the bus strip, right? It'd be so much better if CT can read both input and output meter of bus. Chi ----- Original Message ----- From: Studio Montebello To: ddots-l@xxxxxxxxxxxxx Sent: Tuesday, May 19, 2009 10:59 AM Subject: [ddots-l] Re: Reading Bus Input Meter? Hi Chee! Nice to hear from you, it's been a while. Although I've never tried this, insert a Sonytus compressor on your bus , then you can read the input levels with the F2 key. HTH, Jean Visitez mon site / Visit my site at http://www.studiomontebello.com ----- Original Message ----- From: Chi Kim To: ddots-l@xxxxxxxxxxxxx Sent: Tuesday, May 19, 2009 9:19 AM Subject: [ddots-l] Reading Bus Input Meter? CT reports bus output meter, but is there way to read bus input meter to see how hard I'm driving the bus? If there's a limiter on a bus, I won't know if I'm clipping the bus or not since the output meter will be always below 0. Thanks, Chi