[duxuser] Re: Setting up more than one embosser
- From: "Janet Reynolds" <JReynolds@xxxxxxxxxxxx>
- To: <duxuser@xxxxxxxxxxxxx>
- Date: Fri, 10 Feb 2006 12:04:58 +1300
This is a problem we also have here at RNZFB. We have three identical
embossers, and as soon as you change to a different one the document
embosser settings default to 44, 27. If anyone has a solution that would
be wonderful.
Janet
-----Original Message-----
From: duxuser-bounce@xxxxxxxxxxxxx
[mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Kathy Riessen
Sent: Friday, 10 February 2006 11:59 a.m.
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] Setting up more than one embosser
We have just moved onto Duxbury from Megadots and as such
purchased Duxbury 10.5
We have 2 embossers which are connected to our system and each
is used as often as the other, depending on the type of material being
produced.
My dilemma is:
When trying to set up the Global Embossers I can have both
embossers listed as Brailler Devices, but seem to be able to only set
the Desired Braille Document Formatting on one of them - this one
becoming the embosser of choice for new documents. As soon as I try
changing the settings on another one, that one reverts back to the
suggested settings which are nothing like we use.
This means that everytime I want to select the other embosser in
my Document Setup, I have to manually put in the Desired Document
Formatting for that embosser.
Can I globally set up more than one embosser with our Standard
Parameters, so that I can then select either one in the Document Setup
without having to check whether or not the line width, number of lines,
top margin etc are correct.
Kathy
--------------------------------------------------------------
Kathy Riessen, Braille Production Coordinator
South Australian School for Vision Impaired
1B Duncan Avenue, Park Holme, SA 5043
Tel: 8277 5255, Fax: 8277 5051
Other related posts:
