Arpad, They are all minor changes. I'll have them fixed before the end of the day. Thanks, Paul On Wed, February 8, 2006 2:11 pm, Muranyi, Arpad wrote: > Paul, > > I tried the Verilog portion of your script today > and found a couple of minor things. > > 1) When the IBIS file doesn't have something, > don't print it out in the .dat file. For example, > in a 3-state buffer there are no Vinh and Vinl > parameters, yet you printed them in the .dat > file with zero values. This may apply to all > other parameters, and the VHDL portion too, but > I didn't test it. The only exception to this > rule would be the voltage reference parameters, > which I discussed in an earlier reply. > > 2) You printed three `define statements in the > .dat file. While it can be done that way also, > I would prefer just to use one at the beginning. > If we have multiple definitions, the netlist will > have to use the same number of calls in the > parameter passing section, and that will begin > to look too busy. The whole point of doing it > with this .dat file and macro definition was to > reduce the amount of typing on the netlist. > > 3) Cosmetics: You could put an extra "blank" > line between the various IV and Vt tables to make > it somewhat easier to read (in case someone needs > to look at it with an editor). > > I didn't see a response from you to the suggestions > I made on the voltage reference parameters and the > association of the waveforms with r1, r2, f1, f2. > Do you think you can implement it? > > Thanks, > > Arpad > =================================================--------------------------------------------------------------------- > IBIS Macro website: http://www.sisoft.com/ibis-macro > IBIS Macro archives: //www.freelists.org/archives/ibis-macro > To unsubscribe send an email: > To: ibis-macro-request@xxxxxxxxxxxxx > Subject: unsubscribe > > --------------------------------------------------------------------- IBIS Macro website: http://www.sisoft.com/ibis-macro IBIS Macro archives: //www.freelists.org/archives/ibis-macro To unsubscribe send an email: To: ibis-macro-request@xxxxxxxxxxxxx Subject: unsubscribe