The updated version is attached. 1) Fixed 2) Modified to only one define (verilog) 3) The VHDL file already had blank lines between tables. In Verilog, can I have empty lines in between or do I need "\" on these empty lines? This version has "\"s to be on the safe side. The [... reference] and rise/fall waveform order issues are also fixed. Thanks, Paul On Wed, February 8, 2006 2:51 pm, Paul Fernando wrote: > Arpad, > They are all minor changes. > I'll have them fixed before the end of the day. > Thanks, > Paul > > On Wed, February 8, 2006 2:11 pm, Muranyi, Arpad wrote: >> Paul, >> >> I tried the Verilog portion of your script today >> and found a couple of minor things. >> >> 1) When the IBIS file doesn't have something, >> don't print it out in the .dat file. For example, >> in a 3-state buffer there are no Vinh and Vinl >> parameters, yet you printed them in the .dat >> file with zero values. This may apply to all >> other parameters, and the VHDL portion too, but >> I didn't test it. The only exception to this >> rule would be the voltage reference parameters, >> which I discussed in an earlier reply. >> >> 2) You printed three `define statements in the >> .dat file. While it can be done that way also, >> I would prefer just to use one at the beginning. >> If we have multiple definitions, the netlist will >> have to use the same number of calls in the >> parameter passing section, and that will begin >> to look too busy. The whole point of doing it >> with this .dat file and macro definition was to >> reduce the amount of typing on the netlist. >> >> 3) Cosmetics: You could put an extra "blank" >> line between the various IV and Vt tables to make >> it somewhat easier to read (in case someone needs >> to look at it with an editor). >> >> I didn't see a response from you to the suggestions >> I made on the voltage reference parameters and the >> association of the waveforms with r1, r2, f1, f2. >> Do you think you can implement it? >> >> Thanks, >> >> Arpad >> =================================================--------------------------------------------------------------------- >> IBIS Macro website: http://www.sisoft.com/ibis-macro >> IBIS Macro archives: //www.freelists.org/archives/ibis-macro >> To unsubscribe send an email: >> To: ibis-macro-request@xxxxxxxxxxxxx >> Subject: unsubscribe >> >> > > > --------------------------------------------------------------------- > IBIS Macro website: http://www.sisoft.com/ibis-macro > IBIS Macro archives: //www.freelists.org/archives/ibis-macro > To unsubscribe send an email: > To: ibis-macro-request@xxxxxxxxxxxxx > Subject: unsubscribe > >