Hi, gang. For thos of you who may recall, I had this same problem last year--my wife plugged up another monitor and everthing was fixed. I tried this, but I'm still getting the Freedom Scientific Video Intercept Dialog pop up immediately after booting up. Of course the monitor isn't working. I have gone to the Appearance Resolution field in Control Panel and it says 0%. I cannot remember where to go to change the value to what it needs to be. In Sonar, Caketalk appears and says that it needs the resolution to be this certain value to work properly. I know that value is somewhere in these posts or in tutorial, but could someone send me the values if you know them? Also, can you tell me where to go raise this value with JAWS as my only means to get there? The last time this happened, Freedom Scientific acted as if this was a major bad thing, but it turned out to be nothing really. But this time, the solution isn't that obvious and simple, nor do I know why this has happened a second time. Any help in this matter would be appreciated. I plan to go through the archives and find your responses to the 2009 event. thanks in advance, SLB _________________________________________________________________ The New Busy is not the too busy. Combine all your e-mail accounts with Hotmail. http://www.windowslive.com/campaign/thenewbusy?tile=multiaccount&ocid=PID28326::T:WLMTAGL:ON:WL:en-US:WM_HMP:042010_4