[ddots-l] Re: Assistance needed - Video Intercept again...
- From: "Kevin Gibbs" <kevjazz@xxxxxxxxx>
- To: <ddots-l@xxxxxxxxxxxxx>
- Date: Tue, 27 Apr 2010 09:45:43 -0500
The value is probably 1024x768
-----Original Message-----
From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On
Behalf Of Stacy Blackwell
Sent: Tuesday, April 27, 2010 9:32 AM
To: ddots-l@xxxxxxxxxxxxx
Subject: [ddots-l] Assistance needed - Video Intercept again...
Hi, gang. For thos of you who may recall, I had this same problem last
year--my wife plugged up another monitor and everthing was fixed. I tried
this, but I'm still getting the Freedom Scientific Video Intercept Dialog
pop up immediately after booting up. Of course the monitor isn't working.
I have gone to the Appearance Resolution field in Control Panel and it says
0%. I cannot remember where to go to change the value to what it needs to
be. In Sonar, Caketalk appears and says that it needs the resolution to be
this certain value to work properly. I know that value is somewhere in
these posts or in tutorial, but could someone send me the values if you
know them? Also, can you tell me where to go raise this value with JAWS as
my only means to get there?
The last time this happened, Freedom Scientific acted as if this was a major
bad thing, but it turned out to be nothing really. But this time, the
solution isn't that obvious and simple, nor do I know why this has happened
a second time. Any help in this matter would be appreciated. I plan to go
through the archives and find your responses to the 2009 event. thanks in
advance, SLB
_____
The New Busy is not the too busy. Combine all your e-mail accounts with
Hotmail. Get busy.
<http://www.windowslive.com/campaign/thenewbusy?tile=multiaccount&ocid=PID28
326::T:WLMTAGL:ON:WL:en-US:WM_HMP:042010_4>
Other related posts:
