Also, use a small Q say of 1 or, less.
Regards, Phil Muir P J Muir Productions Music and audio production URL: www.philmuir.com/
Use sweeping technique. In case you don't know how, here it is.** To leave the list, click on the immediately-following link:-
Use parametter eq with peek setting. Inspector eq will do it. Boost the gain a lot like 10 or 13 db. Assign a control nob to a freq and sweep the freq from bottom to top. It'll help you find the freq you want to cut or boost easily.
Chi
----- Original Message ----- From: "Chris Smart" <chris_s@xxxxxxxxxxxx>
To: <ddots-l@xxxxxxxxxxxxx>
Sent: Tuesday, June 13, 2006 12:29 PM
Subject: [ddots-l] Re: EQing live bass
Hmm, I doubt you need much above 5K or maybe 8K. what happens if you drop things above those points?** To leave the list, click on the immediately-following link:-
Also, unless your bass has a low B string, a low E on a bass guitar is around 40 HZ. Maybe boost a little around 110-160HZ; kinda adds warmpth.
At 12:12 PM 6/13/2006, you wrote:It's me again with another question:
I just recorded a few songs with live basses on them. On one of them, I realized that I captured the bass with some hiss, is there anyway I can EQ this out? And, the bass is very boomy, any suggestions on where I should start cutting and boosting to get a clear tight bass. Most of the songs I am working on this album are Reggae and other Caribbean musics that require a tight bass, but not too boomy, as it is in hip-hop. Thanks.
Rod
** To leave the list, click on the immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** ddots-l-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** ddots-l-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq