Mike,
You sent the UNSUBSCRIBE command to the wrong email address. Please use
<duxuser-request@xxxxxxxxxxxxx>. The "-request" part of
the email address is important.
Regards,
Anne Ronco
Duxbury Systems, Inc.
270 Littleton Road, #6; Westford, MA 01886-3523 USA
TEL: + 978-692-3000 FAX: + 978-692-7912
Email (general): info@xxxxxxxxxx
Web site:
http://www.DuxburySystems.com
Duxbury Systems, the first name in software for Braille - since 1975.
At 04:39 PM 4/26/2005 +0100, you wrote:
UNSUBSCRIBE* * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to
Mike Pratt
Tactile Signs Europe Limited
The Red House
Rendlesham Mews
Rendlesham
Woodbridge
Suffolk
IP12 2RJ
T: 01394 420741
F: 01394 420664
www.tactilesignseurope.com
-----Original Message-----
From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx]On
Behalf Of David Holladay
Sent: 26 April 2005 17:32
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] Re: help with a juliet and dbt 10.5
Hello listers:
I really think this problem is caused by the original 10.5 (without
installing DBT 10.5 Service Release 1).
Service Release 1 is *** free *** from the web site.
The easiest way to get the update is to load DBT, click on Help, check for
updates, and see if an update is recommended.
There was a glitch which showed itself if you did not use the full carriage
width of the embosser. Since the Juliet has a huge carriage width, this
glitch frequently made rather bad output on the back side of Juliet output.
Since this glitch involved the back side of interpoint output, yes, one
solution is to ask for single sided output. Getting Service Release 1
installed is a much, much better fix, since it allows you to get proper
interpoint.
-- David Holladay
* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting http://www.freelists.org. The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *
* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting http://www.freelists.org. The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *
