Hi all. I have been playing with this customer to try and get this sorted out for quite a while now. I have a juliet as well and mine seems to work properly. We have reset the embosser and tried a whole range of parameters both in the document and global menus to try and make this work properly but still a huge margin on the reverse side of the page. any info would be appreciated. thanks. Today, I made a discovery. There are two paths to embossing materials. When you go through Duxbury, open the files in Duxbury, and then emboss, the file appears with a wide margin on the overleaf side of the page. When you print through MS Word, you get interpoint with a margin of about three spaces on the overleaf side. This is progress. previously, I have only printed through Duxbury by opening the files and translating and embossing them one by one. There are still questions. What I don't understand is that you have to set a margin of 2 to create a margin of one cell on the front side of the page. If you don't set the margin at 2, the embossing is flush with the perforations of the tractor-feed strips. The big question is why would the emboss feature be different depending on how you access Duxbury? * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *