Insert a new volume value at the end of the fade that restores full volume. Otherwise, your volume will be the last volume at the end of the fade. Sent from my iPhone On Jun 23, 2011, at 10:26 AM, ivanlopez@xxxxxxxxxxx wrote: > Howdy list, > > Do you know how to record an automation fadeout in such a way that it > does not affect the volume in subsequent bars? > > I am experiencing the following problem with recording a fade out volume > change using automation > > On a midi track I have 100 or so bars recorded > > My gradual fadeout is from bar 41 through 49 > > I disable the read enable button soon after I finish my fade out > > I check this same track on bar 65 and I notice that the volume is > noticeably lower than what it should be > > Based on the above described situation, do you know how to record an > automation fadeout in such a way that it does not affect the volume in > subsequent bars? > > I think I am doing what the CT manual says correctly, but don’t know > for sure. > > Thanks, > > Ivan > > > > PLEASE READ THIS FOOTER AT LEAST ONCE! > To leave the list, click on the immediately following link: > ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe > If this link doesn't work then send a message to: > ddots-l-request@xxxxxxxxxxxxx > and in the Subject line type > unsubscribe > For other list commands such as vacation mode, > click on the immediately following link: > ddots-l-request@xxxxxxxxxxxxx?subjectúq or > send a message, to > ddots-l-request@xxxxxxxxxxxxx > and in the Subject line type > faq > PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject�q or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq