I record click tracks via my Beheringer hardware mixer: Do you have a mixer? Robbie Lee. ----- Original Message ----- From: "Mike Tyo" <mtyo@xxxxxxxxxxxx>
To: <ddots-l@xxxxxxxxxxxxx> Sent: Tuesday, August 06, 2013 3:55 PMSubject: [ddots-l] Re: Recording a click track using SONAR's Audio Metronome?
Hi D!J!X!,Thanks for saving my rear-end on that one; I totally forgot about the asio drivers scenario. In that case, you'd have to patch a physical cable to get the metronome recorded to a click track. I did try leaving the playback click turned on when I rendered a mix, but it didn't capture it. I didn't have the "What You Hear" parameter set, nor did I check the box to have the audio play back in real time as the rendering process takes place; so I don't know if either one of those ideas will do the trick. Unless there's a way to route the metronome to a track's input, I guess we're stuck doing things the old fashion way with a cable patched from an out to an in.Mike----- Original Message ----- From: "D!J!X!" <megamansuperior@xxxxxxxxxxx>To: <ddots-l@xxxxxxxxxxxxx> Sent: Tuesday, August 06, 2013 07:44Subject: [ddots-l] Re: Recording a click track using SONAR's Audio Metronome?Hi, 1 thing to note, virtual audio cable will only work if you are usingwdm. If you are using asio drivers for your interface, as you know you canonly select 1 device at a time. So this solution wouldn't work then, well not without some other problems. If you have a saffire interface, this is where the virtual loopback ports come in handy! BTW, I thought you could record a click by setting it to run on playback as well as recording? Sothat when you mix down the bus will include the click track? I think I didthis once a few years ago, don't remember how, but I know it's doable. Or maybe I used a physical cable, can't remember. HTH, D!J!X!PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribeFor other list commands such as vacation mode, click on the immediately following link:ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq
PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribeFor other list commands such as vacation mode, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq orsend a message, to ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type faq