>There has to be a battery of some sorts on the board because the
effects processor is digital, and
Or, more probably, they use non-volitile memory (like flash memory as in
SSD) to save settings.
-- Rich
On 10/1/2018 8:12 AM, Michael Ciarciello wrote:
Hey DJX first of all, I just wanted to apologize that I sent out themessage
stating that your content couldn’t bet read, however after a little while, I
was able to re open the message, and all worked fine.
Toanswer your question on why I think it would come down tot he PC in the end
is because the Board stays on when not plugged in to the uSB port of the
computer system.
I have the same issue with one of my computers where the mixer console kept on
turning it self on/off like Terry’s is doing, and when I switched to another
computer, the mixer console functioned just fine.
The FW 1884 Had a separate firewire card built in to the motherboard, where as
the Signature has the port welded directly in to the board.
There has to be a battery of some sorts on the board because the effects
processor is digital, and retains its patch change when you turn off the board.
It could very well be that the power supply on the mixer console is giving out,
as I just did some research on geersluts and several folks reported issues with
power supply issues.
“sorry Terry”
I suppose we could dance around this problem all night long, but I suggested to
Terry that he call his centre, and speak to them, and they could trouble shoot
the problem, as at this point anything is possible, which is why I’m not
stating what I have stated in previous threads as a 100% solution.
At any rate I’m hoping that terry can resolve this.
Best
On Sep 30, 2018, at 11:32 PM, Michael Ciarciello <m_dsmusic@xxxxxxxx> wrote:PLEASE READ THIS FOOTER AT LEAST ONCE!
Hey DJX your messages have no content lol. Unless my system is going crazy lol.
On Sep 30, 2018, at 10:43 PM, DJ X <megamansuperior@xxxxxxxxxxx> wrote:PLEASE READ THIS FOOTER AT LEAST ONCE!
To leave the list, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe
If this link doesn't work then send a message to:
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
unsubscribe
For other list commands such as vacation mode,
click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subjectתq or
send a message, to
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
faq
To leave the list, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=subscribe
If this link doesn't work then send a message to:
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
unsubscribe
For other list commands such as vacation mode,
click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject�q or
send a message, to
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
faq
